New Membership Platform: Membee

The ACD Club is rolling out a new online membership system. All ACD Club Members should have receivied an email with enrollment instructions. You will use your email address as your login, and select a new password. This account will be used to renew your membership, update membership information, and make changes to your membership record.


This account is NOT THE SAME as your current account which you use to access the ACD Website Forums. Please continue to log into the Forums with the same username and password as you have always used. In the future we may consolidate the two accounts.

Gear Selector Switch Wiring

More
12 May 2020 17:08 #40157 by johnmereness
Replied by johnmereness on topic Gear Selector Switch Wiring
Yes, Pat Leahy - and he actually drives his cars too

JMM

Please Log in or Create an account to join the conversation.

More
12 May 2020 21:29 #40161 by 1748 S
Replied by 1748 S on topic Gear Selector Switch Wiring

JIM.OBRIEN wrote: That's a repop not an original.


Jim are you telling us this switch is a repop or the diagram is a repop? I had to ask to be clear. I'm not understanding what you are referencing the repop to...I will have to look at my original switch to see if I can determine the differences.


Gary Parsons

Please Log in or Create an account to join the conversation.

  • wynlaidig
  • Offline
  • ACD Club Life Member
  • ACD Club Life Member
More
12 May 2020 22:34 #40164 by wynlaidig
Replied by wynlaidig on topic Gear Selector Switch Wiring
JKH drew up the wire guard that fits into the selector arm behind the switch to keep the wires in order. The originals were thin bakelite and often broke. But they should be easy to make, and keep the wires aligned inside the arm. He didn't specify the diameter. I think I have a broken one somewhere that I can measure if need be. See attached file.

This browser does not support PDFs. Please download the PDF to view it: Download PDF

Attachments:

Please Log in or Create an account to join the conversation.

  • JIM.OBRIEN
  • Offline
  • Frequent Forum Contributor
  • Frequent Forum Contributor
More
13 May 2020 21:15 #40168 by JIM.OBRIEN
Replied by JIM.OBRIEN on topic Gear Selector Switch Wiring
Gary - The drawing you posted is a repop Stan was selling. The drawing Wynn posted By Henry and Jim Howell is the original.

Please Log in or Create an account to join the conversation.

  • STEVEN.KUIPER
  • Offline
  • Forum Contributor
  • Forum Contributor
More
14 May 2020 13:02 #40170 by STEVEN.KUIPER
Replied by STEVEN.KUIPER on topic Gear Selector Switch Wiring
for covering soldier connections there is a product called "heat shrink" which is much less noticeable and smaller in diameter than the connector shown on the 1st page here.
essentially a rubber-like black tube(colors are available) that you slide back one of the wires before you soldier them. after soldiering is done slide it over the joint & heat lightly . then it shrinks down to size.

Please Log in or Create an account to join the conversation.

More
14 May 2020 13:37 #40171 by alsancle
Replied by alsancle on topic Gear Selector Switch Wiring
We use this at work. Would it be good in this application?

www.amazon.com/gp/product/B074HZHD9Q

Please Log in or Create an account to join the conversation.

Time to create page: 0.141 seconds
Powered by Kunena Forum