Replacement of spider gear/898 single speed axle

  • Ken Neill
  • Ken Neill's Avatar Topic Author
  • Offline
  • ACD Club Life Member
  • ACD Club Life Member
More
24 May 2004 04:15 #1747 by Ken Neill
Ken Neill created the topic: Replacement of spider gear/898 single speed axle
I am in the process of removing what is commonly called a "spider gear "which has a tooth chipped off, to replace it with a good one. I would like to communicate with someone who has done this procedure, as it is not working out as the shop manual describes it. Specifically, the locking pin cannot be removed because it will not clear the differential adjuster lock without removing the latter, and I have not removed it for fear it may upset some critical adjustment. I would be grateful for any information anyone might venture to offer.

Please Log in or Create an account to join the conversation.

More
25 May 2004 03:43 #1749 by Lycoming-8
Lycoming-8 replied the topic:
I would check with Glen Pray @ 918-251-3161. He has worked on a lot of these cars and knows how to set up a rear end for good life and minimal noise. He still had some of the rear end gear parts not too many years ago.

'31 Auburn Coupe

Please Log in or Create an account to join the conversation.

  • Ken Neill
  • Ken Neill's Avatar Topic Author
  • Offline
  • ACD Club Life Member
  • ACD Club Life Member
More
25 May 2004 04:46 #1750 by Ken Neill
Ken Neill replied the topic: replacement of spider gear/31 898
Thank you very much for your help Lycoming 8

Please Log in or Create an account to join the conversation.

Moderators: Joe Holderman
Time to create page: 0.056 seconds
Powered by Kunena Forum