- Posts: 7
- Thank you received: 1
Re-Babbiting Sources
- auburn-kid
- Offline
- ACD Club Life Member
-
Registered
Less
More
01 Jan 2018 16:59 #33968
by auburn-kid
Kellie Janousek
Life Member #170
Replied by auburn-kid on topic Re-Babbiting Sources
We have used Paul's Rod Shop in Kansas City. Reasonable and relatively quick service.
Kellie Janousek
Life Member #170
Please Log in or Create an account to join the conversation.
- johnmereness
- Offline
- Moderator
-
Registered
Less
More
- Posts: 767
- Thank you received: 159
30 Dec 2017 06:52 #33967
by johnmereness
JMM
Replied by johnmereness on topic Re-Babbiting Sources
Curt, I would investigate using inset bearings in the rods
JMM
Please Log in or Create an account to join the conversation.
- ilikescars
- Offline
- Moderator
-
Registered
Less
More
- Posts: 213
- Thank you received: 20
22 Dec 2017 15:45 #33904
by ilikescars
Replied by ilikescars on topic Re-Babbiting Sources
Not sure where you are located, but one good guy is John Schnittker 847-253-6740
[email protected]
[email protected]
Please Log in or Create an account to join the conversation.
- mikespeed35
- Offline
- ACD Club Life Member
-
Registered
Less
More
- Posts: 886
- Thank you received: 194
22 Dec 2017 05:19 #33901
by mikespeed35
Mike Huffman
Replied by mikespeed35 on topic Re-Babbiting Sources
Paul's Rod and Bearing. I think Kansas City.
CORDiallyMike
CORDiallyMike
Mike Huffman
Please Log in or Create an account to join the conversation.
- Curt Schulze
- Offline
- Moderator
-
Registered
Less
More
- Posts: 1014
- Thank you received: 140
22 Dec 2017 00:58 #33899
by Curt Schulze
The bitterness of poor quality remains long after the sweetness of low price is forgotten.
Be of Good Cheer
Curt
Replied by Curt Schulze on topic Re-Babbiting Sources
Ya know, insert bearings are babbit They run as well in old cars as they do in billions of new cars. New technology is best
The bitterness of poor quality remains long after the sweetness of low price is forgotten.
Be of Good Cheer
Curt
The following user(s) said Thank You: johnmereness
Please Log in or Create an account to join the conversation.
- curtiss
- Topic Author
- Offline
- Premium Forum User
-
Registered
Less
More
- Posts: 108
- Thank you received: 4
21 Dec 2017 15:56 #33896
by curtiss
Re-Babbiting Sources was created by curtiss
Who do you all use to re-babbitt your bearings ? I have only found Hart so far?
Thanks,
Curt
Thanks,
Curt
Please Log in or Create an account to join the conversation.