New Membership Platform: Membee

The ACD Club is rolling out a new online membership system. All ACD Club Members should have receivied an email with enrollment instructions. You will use your email address as your login, and select a new password. This account will be used to renew your membership, update membership information, and make changes to your membership record.


This account is NOT THE SAME as your current account which you use to access the ACD Website Forums. Please continue to log into the Forums with the same username and password as you have always used. In the future we may consolidate the two accounts.

Ring n Pinion Gear Setup

  • 1748 S
  • Topic Author
  • Offline
  • ACD Club Member
  • ACD Club Member
More
04 Jun 2020 21:14 #40304 by 1748 S
Ring n Pinion Gear Setup was created by 1748 S
I have been searching for the proper procedures for setting the rin n pinion gear in the trans housing. I have not found what I'm looking for. I realize the shim pack under the bottom pinion shaft front bearing retainer clip. But what about the side bearing setup?on the ring gear? I also do not know how what the contact pattern is supposed to look like.


Gary Parsons

Please Log in or Create an account to join the conversation.

  • JIM.OBRIEN
  • Offline
  • Frequent Forum Contributor
  • Frequent Forum Contributor
More
05 Jun 2020 00:12 #40305 by JIM.OBRIEN
Replied by JIM.OBRIEN on topic Ring n Pinion Gear Setup
The Cord Transmission manual tells you how to do it.

Please Log in or Create an account to join the conversation.

  • 1748 S
  • Topic Author
  • Offline
  • ACD Club Member
  • ACD Club Member
More
05 Jun 2020 13:34 #40307 by 1748 S
Replied by 1748 S on topic Ring n Pinion Gear Setup
thanks Jim. Are you referring to the new trans booklet or the older one many of us use now?


Gary Parsons

Please Log in or Create an account to join the conversation.

  • JIM.OBRIEN
  • Offline
  • Frequent Forum Contributor
  • Frequent Forum Contributor
More
09 Jun 2020 01:48 #40329 by JIM.OBRIEN
Replied by JIM.OBRIEN on topic Ring n Pinion Gear Setup
It's in the existing booklet (and in the updated one). Look under the assembly instructions, Section 8 Step 28
The following user(s) said Thank You: 1748 S

Please Log in or Create an account to join the conversation.

Time to create page: 0.053 seconds
Powered by Kunena Forum