- Posts: 1745
- Thank you received: 134
Throwout Bearing
- 1748 S
- Topic Author
- Offline
- Platinum Forum User
-
Registered
Less
More
16 May 2020 16:42 #40183
by 1748 S
Replied by 1748 S on topic Throwout Bearing
Thanks George. This clear explanation sure helps. Its answers like this that makes our cars seem simple.
Gary Parsons
Gary Parsons
Please Log in or Create an account to join the conversation.
- George van Nostrand
- Offline
- Moderator
-
Registered
Less
More
- Posts: 113
- Thank you received: 35
16 May 2020 16:13 #40182
by George van Nostrand
Restoring 1936 Cord Westchester sedan.2023 A
Replied by George van Nostrand on topic Throwout Bearing
Gary I found JK Howell's directions. 1. Remove release bearing guide and remove 1/4" to 9/32" from face 2. reinstall guide. 3. install two seals into hole in clutch housing , in front of guide. lips facing transmission. Grease sealing lips and use care when installing transmission.
Restoring 1936 Cord Westchester sedan.2023 A
Please Log in or Create an account to join the conversation.
- uconn_1965
- Offline
- Moderator
-
Registered
Less
More
- Posts: 369
- Thank you received: 97
14 May 2020 19:37 #40175
by uconn_1965
Replied by uconn_1965 on topic Throwout Bearing
Please Log in or Create an account to join the conversation.
- 1748 S
- Topic Author
- Offline
- Platinum Forum User
-
Registered
Less
More
- Posts: 1745
- Thank you received: 134
14 May 2020 17:39 #40172
by 1748 S
Throwout Bearing was created by 1748 S
Our 810 812 Cord clutch throw out bearings ride on a sleeve. We can purchase two seals from Stan so I did. No directions other what is printed in the catalog telling to "some machining required"....My question is which end do I machine so the seals fit? I suspect its the end that bolts to the bell housing differential wall behind the clutch n throw out bearing. Any ideas?
Gary Parsons
Gary Parsons
Please Log in or Create an account to join the conversation.