Exhaust pipe insulation

  • Josh Malks
  • Josh Malks's Avatar Topic Author
  • Offline
  • ACD Club Past President
  • ACD Club Past President
More
27 Jun 2004 19:48 #1875 by Josh Malks
Josh Malks replied the topic: Exhaust pipe insulation photos
The attached photos show the original asbestos insulation moldings as they came off one pipe of my 810; note that the top end has broken off. Masking tape is holding the two halves together here. As you can see in the end shot, these ARE two halves. They were held together by four (on each side) of the clamp shown. Also a closeup to show the texture --- no socks or wraps here.

Other photos show how we reproduced the original using kaolin clay. (I have some left --- anybody wanna play?









Josh B. Malks
810 2087A
ACD Club Life Member
ACD Newsletter editor
Past president
www.automaven.com

Check out CORD COMPLETE at www.cordcomplete.com

Please Log in or Create an account to join the conversation.

Moderators: Joe Holderman
Time to create page: 0.056 seconds
Powered by Kunena Forum