New Membership Platform: Membee

The ACD Club is rolling out a new online membership system. All ACD Club Members should have receivied an email with enrollment instructions. You will use your email address as your login, and select a new password. This account will be used to renew your membership, update membership information, and make changes to your membership record.


This account is NOT THE SAME as your current account which you use to access the ACD Website Forums. Please continue to log into the Forums with the same username and password as you have always used. In the future we may consolidate the two accounts.

Changing out Cord 810 Gauges

  • Bill Hummel
  • Bill Hummel's Avatar Topic Author
  • Offline
  • ACD Club Past President
  • ACD Club Past President
More
07 Jun 2003 10:59 #360 by Bill Hummel
Changing out Cord 810 Gauges was created by Bill Hummel
I am thinking about changing out all of my gauges myself.

What is involved?

Can I just come in from behind the dash, unscrew them and replace them? Or is there a secondary panel that I have to remove first?

I also have new dashpanel. That obviously goes on from the front.

Please Log in or Create an account to join the conversation.

  • Josh Malks
  • Josh Malks's Avatar
  • Offline
  • ACD Club Past President
  • ACD Club Past President
More
07 Jun 2003 17:19 #361 by Josh Malks
Replied by Josh Malks on topic Changing out Cord 810 Gauges
All of the gauges are removed/replaced from the back. Take out the seat cushions to provide a bit more room. Lay down a comforter for --- well, comfort. Lie crosswise on the floor. Some gauges will require your head to be pointing to the left, some to the right. Use a fluorescent light to avoid burns. Be patient, and ask the womenfolk and others with delicate ears to leave the garage.

Josh B. Malks
810 2087A
ACD Club Life Member
ACD Newsletter editor
Past president
www.automaven.com

Check out CORD COMPLETE at www.cordcomplete.com

Please Log in or Create an account to join the conversation.

Time to create page: 0.111 seconds
Powered by Kunena Forum