- Posts: 767
- Thank you received: 159
3/4" hose clamp source
- johnmereness
- Offline
- Moderator
-
Registered
Less
More
25 Aug 2020 18:32 #40798
by johnmereness
JMM
Replied by johnmereness on topic 3/4" hose clamp source
Same tubing on a Cord as on an Auburn Columbia rear axle.
JMM
Please Log in or Create an account to join the conversation.
- wynlaidig
- Topic Author
- Offline
- ACD Club Life Member
-
Registered
Less
More
- Posts: 259
- Thank you received: 44
25 Aug 2020 11:45 - 25 Aug 2020 11:46 #40794
by wynlaidig
Replied by wynlaidig on topic 3/4" hose clamp source
Restoration Specialties said the company that made the 3/4" clamps discontinued them. I don't think they are the same as the ones Auburn uses... these are for the extra thick vacuum hoses (3/4" OD) on the shift cylinder, which Auburn does not have.
Last edit: 25 Aug 2020 11:46 by wynlaidig. Reason: Typo
Please Log in or Create an account to join the conversation.
- Curt Schulze
- Offline
- Moderator
-
Registered
Less
More
- Posts: 1014
- Thank you received: 140
21 Aug 2020 22:57 #40779
by Curt Schulze
The bitterness of poor quality remains long after the sweetness of low price is forgotten.
Be of Good Cheer
Curt
Replied by Curt Schulze on topic 3/4" hose clamp source
If the Cords are the same as 34-36 Auburn the lines are 7/16 ID and a 11/16 OD copper lines. Special hose clamps have a part number of 7S4. those are available.
The bitterness of poor quality remains long after the sweetness of low price is forgotten.
Be of Good Cheer
Curt
Please Log in or Create an account to join the conversation.
- wynlaidig
- Topic Author
- Offline
- ACD Club Life Member
-
Registered
Less
More
- Posts: 259
- Thank you received: 44
21 Aug 2020 15:59 #40774
by wynlaidig
3/4" hose clamp source was created by wynlaidig
Does anyone have a source for the correct 3/4" hose clamps used on the shift cylinder vacuum hoses? Restoration Specialties and Restoration Supply both have 5/8" clamps but they are too small. I can get 7/8" - 1" from TheFillingStation or Willy's Jeep (part number GM-1200) but they are a size too big. I have not had luck so far in finding 3/4".
Please Log in or Create an account to join the conversation.