New Membership Platform: Membee

The ACD Club is rolling out a new online membership system. All ACD Club Members should have receivied an email with enrollment instructions. You will use your email address as your login, and select a new password. This account will be used to renew your membership, update membership information, and make changes to your membership record.


This account is NOT THE SAME as your current account which you use to access the ACD Website Forums. Please continue to log into the Forums with the same username and password as you have always used. In the future we may consolidate the two accounts.

851/852 Front Brake Drum's Hub "Felt" Grease Seals Needed...

More
15 Jun 2020 23:23 #40371 by G-T
I need to replace the (2) front Brake Drum's Grease "Felt" Seals and in the Auburn Factory Parts Book they are part number: E 60579.
I also would like to get 4 small rubber Cover for Brake Back Plate Inspection ( Adjusting) Hole part number: E 10458. Thanks for anny lead to find those parts...!!

Please Log in or Create an account to join the conversation.

  • mikespeed35
  • mikespeed35's Avatar
  • Offline
  • ACD Club Life Member
  • ACD Club Life Member
More
16 Jun 2020 04:12 #40373 by mikespeed35
The brake backing plate rubber covers can be gotten at NAPA, and it is best to replace the spindle seals with modern seals. measure housing and shaft size and check with a bearing Co.

Mike Huffman
The following user(s) said Thank You: 1748 S

Please Log in or Create an account to join the conversation.

More
17 Jun 2020 15:24 #40375 by Curt Schulze
34-36 Auburn did not use rubber plugs (covers) to plug the brake adjusting holes. Metal snap in covers were used.

The bitterness of poor quality remains long after the sweetness of low price is forgotten.
Be of Good Cheer
Curt
The following user(s) said Thank You: Jonathan Richards

Please Log in or Create an account to join the conversation.

More
17 Jun 2020 21:48 #40377 by G-T
OK but since the car is a driver regular rubber cover will be fine; Thanks...!!

Please Log in or Create an account to join the conversation.

More
17 Jun 2020 21:55 #40378 by G-T
Well I made some search and found that it seem like Auburn were the only car that came from the factory with those particular Brake Drum style using this "Felt" type of grease seals; they are so damp of oil that this is surprising that nobody had already found an alternative for this problem, Thank You...!!

Please Log in or Create an account to join the conversation.

More
17 Jun 2020 23:12 #40379 by pete kelly
PM sent

Please Log in or Create an account to join the conversation.

Time to create page: 0.054 seconds
Powered by Kunena Forum