New Membership Platform: Membee

The ACD Club is rolling out a new online membership system. All ACD Club Members should have receivied an email with enrollment instructions. You will use your email address as your login, and select a new password. This account will be used to renew your membership, update membership information, and make changes to your membership record.


This account is NOT THE SAME as your current account which you use to access the ACD Website Forums. Please continue to log into the Forums with the same username and password as you have always used. In the future we may consolidate the two accounts.

timing chain widths

More
20 Nov 2020 16:20 #41532 by Chuck
timing chain widths was created by Chuck
Was hoping someone could give me some information on the different widths of timing chains for 36 Auburn S/C and non as well as S/C Cord and non supercharged Cord timing chains

Please Log in or Create an account to join the conversation.

More
20 Nov 2020 16:58 #41533 by 1748 S
Replied by 1748 S on topic timing chain widths
The supercharged Cord chain is 1 1/2 inch wide with 1/2 inch pitch. The non supercharged chain is 1 1/4 inch wide with 1/2 inch pitch. They are the same length or link count. Of course the gears are different width from supercharged is 1 1/2 to non supercharged at 1 1/4. I can't offer much on the Auburn chains because there is a 6 cylinder, a 8 cylinder and a 12 cylinder. EGGE machine shop offers a replacement chain made by another manufacture. Original chains were Whitney and some appear on ebay sometimes.


Gary Parsons

Please Log in or Create an account to join the conversation.

  • JIM.OBRIEN
  • Offline
  • Frequent Forum Contributor
  • Frequent Forum Contributor
More
20 Nov 2020 21:48 #41535 by JIM.OBRIEN
Replied by JIM.OBRIEN on topic timing chain widths
CORRECTION ON THE CORD TIMING CHAINS - The standard timing chains are 1 1/4" as Gary said. The timing chain gears are 1.285" wide. The Supercharged timing chains are 1 3/4" wide. The S/C timing chain gears are 1.780" wide.
The following user(s) said Thank You: 1748 S

Please Log in or Create an account to join the conversation.

Time to create page: 0.056 seconds
Powered by Kunena Forum