Cord sedan body

  • Josh Malks
  • Josh Malks's Avatar Topic Author
  • Offline
  • ACD Club Past President
  • ACD Club Past President
More
20 May 2004 15:46 #1738 by Josh Malks
Josh Malks created the topic: Cord sedan body
If you'd like to see how the Cord sedan body and roof were pieced together, check out Ray Exton's Westchester in the Picture Gallery.

Josh B. Malks
810 2087A
ACD Club Life Member
ACD Newsletter editor
Past president
www.automaven.com

Check out CORD COMPLETE at www.cordcomplete.com

Please Log in or Create an account to join the conversation.

  • balinwire
  • balinwire's Avatar
  • Offline
  • Frequent Forum Contributor
  • Frequent Forum Contributor
More
22 May 2004 13:43 #1741 by balinwire
balinwire replied the topic: gas filler door
If you look closley at the filler door of Rays car it has a small pull. I understood all the cars had locks on the filler doors. I have a similar arrangment pull and it appears to be stock. There would have to be a large hole to set in a fuel-door lockset. Is this a stock filler door? Looks like an original cover.

Please Log in or Create an account to join the conversation.

  • Josh Malks
  • Josh Malks's Avatar Topic Author
  • Offline
  • ACD Club Past President
  • ACD Club Past President
More
22 May 2004 15:09 #1743 by Josh Malks
Josh Malks replied the topic: Fuel door
A locking fuel door was stock. The cylinder was entirely contained in the knob, so the hole was relatively small.

Non-locking knobs were after-market replacements, offered by the ACD factory when the originals were gone. (Or, you could stop at your local hardware store and buy a nice kitchen cabinet knob . . .) :D

Josh B. Malks
810 2087A
ACD Club Life Member
ACD Newsletter editor
Past president
www.automaven.com

Check out CORD COMPLETE at www.cordcomplete.com

Please Log in or Create an account to join the conversation.

Time to create page: 0.052 seconds
Powered by Kunena Forum