Source for Ball Bearings and Bearing Races Steering box

  • curtiss
  • curtiss's Avatar Topic Author
  • Offline
  • Forum Contributor
  • Forum Contributor
More
13 Jun 2016 14:43 #31257 by curtiss
curtiss created the topic: Source for Ball Bearings and Bearing Races Steering box
I would like to replace the ball bearings in my Ross steering box, they are .31 in size and if I can find them I would like to replace the races also pictured below.

Any sources you can think of?




Please Log in or Create an account to join the conversation.

More
14 Jun 2016 02:48 #31262 by Tom_Parkinson
Tom_Parkinson replied the topic: Re: Source for Ball Bearings and Bearing Races Steering box
Hi,

.3125 is 5/16, and they are readily available from Mcmaster.com.

--Tom

With brakes, two cylinders are better than one.

Editor-in-Chief, The Hardtop News Magazine, the Journal of the Michiana Dunes Region, Lambda Car Club International

See pix of 1509A here: http://mbcurl.me/YCSE

Please Log in or Create an account to join the conversation.

  • curtiss
  • curtiss's Avatar Topic Author
  • Offline
  • Forum Contributor
  • Forum Contributor
More
14 Jun 2016 13:27 #31267 by curtiss
curtiss replied the topic: Re: Source for Ball Bearings and Bearing Races Steering box

Tom_Parkinson wrote: Hi,

.3125 is 5/16, and they are readily available from Mcmaster.com.

--Tom


Thanks, just what I was looking for. Funny thing is I ordered rubber parts form them last year and totally forgot about them.

Please Log in or Create an account to join the conversation.

  • curtiss
  • curtiss's Avatar Topic Author
  • Offline
  • Forum Contributor
  • Forum Contributor
More
15 Jun 2016 16:29 #31273 by curtiss
curtiss replied the topic: Re: Source for Ball Bearings and Bearing Races Steering box

Tom_Parkinson wrote: Hi,

.3125 is 5/16, and they are readily available from Mcmaster.com.

--Tom



The ball bearings arrived today and were perfect, thanks for the lead! I could not find the races so I am going to use my originals as they are not too bad off.

Please Log in or Create an account to join the conversation.

Time to create page: 0.054 seconds
Powered by Kunena Forum