- Posts: 1012
- Thank you received: 140
SS side mounts moldings
- Curt Schulze
- Offline
- Moderator
-
Registered
Less
More
01 May 2016 00:13 #31030
by Curt Schulze
The bitterness of poor quality remains long after the sweetness of low price is forgotten.
Be of Good Cheer
Curt
Replied by Curt Schulze on topic Re: SS side mounts moldings
I believe the tread cover trim molding is very close to .71 or slightly under 3/4" this is the same as the 34-36. If this is what you are looking for, I have a couple of new ones.
The bitterness of poor quality remains long after the sweetness of low price is forgotten.
Be of Good Cheer
Curt
Please Log in or Create an account to join the conversation.
- Rlamb10769
- Topic Author
- Offline
- Senior Member
-
Registered
Less
More
- Posts: 50
- Thank you received: 2
30 Apr 2016 21:22 #31028
by Rlamb10769
Richard Lambert
ACD #3371
SS side mounts moldings was created by Rlamb10769
Looking for the stainless steel moldings on my side mounts for 31 Auburn.
The width of mine are 11/16". I have new ones that came with my car when I bought it but they are only 1/2" wide. I would need to drill all the spot welds out to remove the inter holder of the moldings then figure out how to attach the new moldings. Would be easier to find the correct width.
Hope someone makes some reproductions.
Thanks,
Richard
The width of mine are 11/16". I have new ones that came with my car when I bought it but they are only 1/2" wide. I would need to drill all the spot welds out to remove the inter holder of the moldings then figure out how to attach the new moldings. Would be easier to find the correct width.
Hope someone makes some reproductions.
Thanks,
Richard
Richard Lambert
ACD #3371
Please Log in or Create an account to join the conversation.